This page summarizes the results of 10-fold cross-validation for species, created Fri May 31 15:20:14 BST 2019 using 'dismo' version 1.1-4 & Maxent version 3.4.1. The individual models are here: [0] [1] [2] [3] [4] [5] [6] [7] [8] [9]

The next picture is the receiver operating characteristic (ROC) curve for the same data, again averaged over the replicate runs. Note that the specificity is defined using predicted area, rather than true commission (see the paper by Phillips, Anderson and Schapire cited on the help page for discussion of what this means). The average test AUC for the replicate runs is 0.919, and the standard deviation is 0.008.

These curves show how each environmental variable affects the Maxent prediction. The curves show how the predicted probability of presence changes as each environmental variable is varied, keeping all other environmental variables at their average sample value. Click on a response curve to see a larger version. Note that the curves can be hard to interpret if you have strongly correlated variables, as the model may depend on the correlations in ways that are not evident in the curves. In other words, the curves show the marginal effect of changing exactly one variable, whereas the model may take advantage of sets of variables changing together. The curves show the mean response of the 10 replicate Maxent runs (red) and and the mean +/- one standard deviation (blue, two shades for categorical variables).

In contrast to the above marginal response curves, each of the following curves represents a different model, namely, a Maxent model created using only the corresponding variable. These plots reflect the dependence of predicted suitability both on the selected variable and on dependencies induced by correlations between the selected variable and other variables. They may be easier to interpret if there are strong correlations between variables.

The following table gives estimates of relative contributions of the environmental variables to the Maxent model. To determine the first estimate, in each iteration of the training algorithm, the increase in regularized gain is added to the contribution of the corresponding variable, or subtracted from it if the change to the absolute value of lambda is negative. For the second estimate, for each environmental variable in turn, the values of that variable on training presence and background data are randomly permuted. The model is reevaluated on the permuted data, and the resulting drop in training AUC is shown in the table, normalized to percentages. As with the variable jackknife, variable contributions should be interpreted with caution when the predictor variables are correlated. Values shown are averages over replicate runs.

Variable | Percent contribution | Permutation importance |
---|---|---|

band7 | 35.9 | 36.8 |

dem | 21.1 | 16.8 |

band5 | 19 | 7.6 |

vi | 13.5 | 2.3 |

band1 | 6 | 11 |

band4 | 2.9 | 12.3 |

band6 | 0.7 | 12.4 |

slope | 0.6 | 0.2 |

band2 | 0.2 | 0.7 |

band3 | 0 | 0 |

Command line to repeat this species model: java density.MaxEnt nowarnings noprefixes -E "" -E species responsecurves outputdirectory=C:\Users\delvi\AppData\Local\Temp\RtmpKAQ5cS/raster/maxent/72248510402 samplesfile=C:\Users\delvi\AppData\Local\Temp\RtmpKAQ5cS/raster/maxent/72248510402/presence environmentallayers=C:\Users\delvi\AppData\Local\Temp\RtmpKAQ5cS/raster/maxent/72248510402/absence replicates=10 autorun novisible